How to Calculate Concrete Volume for Slabs, Footings, and Patios (Step-by-Step)
🛠️ Free toolConcrete CalculatorGet the answer instantly: enter length, width and depth in our free concrete calculator to see cubic yards and the number of bags you need. Open tool →Ordering too little concrete means a cold joint or a second delivery fee; ordering too much wastes money. The good news is that concrete volume is simple geometry. In the U.S., ready-mix concrete is sold by the cubic yard, and bagged mix by weight. This guide shows you how to calculate both for the most common DIY projects.
The basic concrete formula
Volume is length × width × depth. The only trick is keeping units consistent – depth is usually measured in inches, so convert it to feet first.
Cubic feet = length (ft) × width (ft) × depth (in) ÷ 12
Cubic yards = cubic feet ÷ 27
There are 27 cubic feet in one cubic yard (3 ft × 3 ft × 3 ft).
Example 1: A 10 × 10 ft patio slab
A standard patio slab is 4 inches thick.
- 10 ft × 10 ft × (4 ÷ 12) ft = 33.3 cubic feet
- 33.3 ÷ 27 = 1.23 cubic yards
- Add 10% for waste and uneven subgrade: 1.23 × 1.10 ≈ 1.36 cubic yards
Most suppliers sell in quarter- or half-yard increments, so you would order about 1.5 yards. Check your numbers with the cubic yards calculator.
Typical slab thicknesses
| Project | Common thickness | Concrete per 100 sq ft |
|---|---|---|
| Walkway / patio | 4 in | 1.23 yd³ |
| Shed or garage floor | 4–5 in | 1.23 – 1.54 yd³ |
| Residential driveway | 4–6 in | 1.23 – 1.85 yd³ |
| Heavy equipment pad | 6 in + | 1.85 yd³ + |
Always confirm required thickness, base and reinforcement with your local building department.
Example 2: Footings
Continuous footings are just long, narrow slabs. For a footing 40 ft long, 16 in wide and 8 in deep:
- Convert to feet: width 16 ÷ 12 = 1.333 ft; depth 8 ÷ 12 = 0.667 ft
- 40 × 1.333 × 0.667 = 35.6 cubic feet
- 35.6 ÷ 27 = 1.32 cubic yards (≈1.45 yd³ with 10% extra)
Example 3: Round columns and post holes
For cylinders (sonotubes, post holes), use the area of a circle:
Cubic feet = π × (diameter ÷ 2)² × height (all in feet)
A 12-inch-diameter column 4 ft tall: 3.1416 × 0.5² × 4 = 3.14 cubic feet each. Ten columns need 31.4 ft³, or about 1.16 cubic yards.
Bags vs. ready-mix: how many bags do you need?
Bagged concrete yields roughly the following (check the label of your brand):
| Bag size | Approx. yield | Bags per cubic yard |
|---|---|---|
| 40 lb | 0.30 ft³ | 90 |
| 60 lb | 0.45 ft³ | 60 |
| 80 lb | 0.60 ft³ | 45 |
The 10 × 10 patio above (≈36.7 ft³ with waste) would need about 62 bags of 80 lb mix – a lot of mixing! As a rule of thumb, projects over about 1 cubic yard are usually easier and often cheaper with ready-mix delivery.
Don’t forget the base and reinforcement
- Gravel base: most slabs sit on 4 in of compacted gravel. Estimate it with the gravel calculator.
- Rebar or mesh: calculate bar count and length with the rebar calculator – see our rebar spacing guide.
- Block walls: use the concrete block calculator for CMU walls.
Ordering ready-mix: what to tell the supplier
- Volume in cubic yards (including your waste allowance).
- Strength – residential slabs commonly use mixes in the 3,000–4,000 psi range; follow your plans or local code.
- Slump – how wet the mix is; ask your supplier for a recommendation for your placement method.
- Air entrainment – recommended for exterior concrete in freeze–thaw climates.
- Access – truck chute reach, whether you need a pump or wheelbarrows, and any short-load fees for small orders.
Common estimating mistakes
- Forgetting to convert inches to feet – a 4-inch slab is 0.333 ft deep, not 4 ft.
- Ignoring uneven subgrade – a ½-inch dip across a large slab adds up quickly.
- Leaving out thickened edges – many slabs have deeper perimeters; calculate them as footings.
- Rounding down – running short mid-pour is far more expensive than a little extra.
Frequently asked questions
How many cubic yards of concrete do I need for a 10x10 slab?
A 10 × 10 ft slab 4 inches thick needs about 1.23 cubic yards. With a 10% waste allowance, order about 1.4–1.5 cubic yards.
How much extra concrete should I order?
Most contractors add 5–10% to cover spillage, uneven subgrade and form deflection. Add more for irregular shapes.
How many 80 lb bags of concrete make a yard?
About 45 bags, since each 80 lb bag yields roughly 0.60 cubic feet and a cubic yard is 27 cubic feet.
How thick should a concrete patio be?
Four inches is standard for patios and walkways. Driveways and areas with vehicle traffic are often 4–6 inches. Check local code requirements.